4.3 inch HDMI Controller board with customized LCD screen Color TFT LCD Display
1.Brightness can be customized,brightness can be up to 1000nits.
2.Interface can be customized,Interfaces TTL RGB,MIPI, LVDS,SPI,eDP is available.
3.Display’s view angle can be customized,full angle and partial view angle is available.
4.Touch Panel can be customized,our LCD display can be with custom resistive touch and capacitive touch panel.
5.PCB Board solution can customized,our LCD display can support with controller board with HDMI,VGA interface.
6.Special share LCD can be customized,such as bar,square and round LCD display can be customized or any other special shaped display is available to custom.
| Item | Standard Values |
| Size |
4.3 inch |
| LCM Resolution supported |
800(horizontal)*480(Vertical) |
| Pixel Configuration |
R.G.B.-Stripe |
| Interface |
HDMI/VGA |
| Connect type |
Cable |
| USB(CTP) |
Micro-USB |
| Key |
5key+interface |
| Audio |
support |
| PCB (W x H x D) (mm) |
105.50*83.40*1.6 |
| LCM connector |
40PIN-0.5S |
| CTP connector |
6PIN-1.0S |
| HDMI connector |
HDMI-019S |
| Key connector |
8PIN-1.25S |
| Speaker connector |
4PIN-1.25S |
|
Item |
Symbol |
MIN |
MAX |
Unit |
Remark |
|
Supply Voltage |
VDD |
11.5 |
12 |
12.5 |
|
|
Direct Current(without LCM) |
Idd |
- |
80 |
- |
|
|
Backlight Current |
Iled |
- |
20 |
- |
|
|
Operating Temperature |
TOPR |
-20 |
70 |
℃ |
|
|
Storage Temperature |
TSTG |
-30 |
80 |
℃ |
USB PIN-MAP
| Pin | Signal | Description |
| 1 | VDD | Power supply(5V) |
| 2 | - | Data- |
| 3 | D+ | Data+ |
| 4 | ID | No connected |
| 5 | GND | GND |
HDMI PIN-MAP
| Pin | Signal | Description |
| 1 | TMDS Data 2+ | TMDS Transition differential signal 2+ |
| 2 | TMDS Data2 Sh | Data2 Shielding ground |
| 3 | TMDS Data 2- | TMDS Transition differential signal 2- |
| 4 | TMDS Data 1+ | TMDS Transition differential signal 1+ |
| 5 | TMDS Data1 Sh | Data1 Shielding ground |
| 6 | TMDS Data 1- | TMDS Transition differential signal 1- |
| 7 | TMDS Data 0+ | TMDS Transition differential signal 0+ |
| 8 | TMDS Data 0 S | Data0 Shielding ground |
| 9 | TMDS Data 0- | TMDS Transition differential signal 0- |
| 10 | TMDS Clock+ | TMDS Transition differential signal Clock+ |
| 11 | TMDS Clock Sh | Clo6ck Shielding ground |
| 12 | TMDS Clock- | TMDS Transition differential signal Clock- |
| 13 | CEC | Electronic protocol CEC |
| 14 | NC | NC |
| 15 | SCL | I2C Clock Line |
| 16 | SDA | I2C DATA Line |
| 17 | DDC/CEC GND | Data display channel |
| 18 | +5V | +5V Power |
| 19 | Hot Plug Detec | Hot Plug Detec |
SPEAKER PIN-MAP
| Pin | Signal | Description |
| 1 | R+ | Right audio channel+ |
| 2 | - | Right audio channel- |
| 3 | - | Left audio channel- |
| 4 | L+ | Left audio channel+ |
JW1 DC PIN-MAP
| Pin | Signal | Description |
| 1 | 12V | Power supply(12V) |
| 2 | GND | Ground |
KEY PIN-MAP
| Pin | Signal | Description |
| 1 | DOWN | Menu down key |
| 2 | UP | Menu up key |
| 3 | EXIT | Menu exit key |
| 4 | POWER | Power on/off key |
| 5 | MENU | Menu key |
| 6 | LED | Status indicator LED |
| 7 | GND | Ground |
| 8 | 3.3V | Power supply for key PCB |
LCM PIN-MAP
| Pin | Signal | Description |
| 1 | VLED- | Backlight LED Cathode |
| 2 | VLED+ | Backlight LED Anode. |
| 3 | GND | Ground |
| 4 | VDD | Power supply |
| 5~12 | R0~R7 | Data bus |
| 13~20 | G0~G7 | Data bus |
| 21~28 | B0~B7 | Data bus |
| 29 | GND | Ground |
| 30 | DCLK | Dot clock signal input. Latching input data at its rising edge. |
| Normally pulled high. | ||
| 31 | DISP | DISP=“1”: Normally operation (Default) |
| DISP=“0”: Timing controller, source driver will turn off ,all output are High-Z. | ||
| 32 | HSYNC | Horizontal sync input. Negative polarity. |
| 33 | VSYNC | Vertical sync input Negative polarity |
| 34 | DE | Data enable input. Active high to enable the input data bus under “DE Mode. ” |
| 35 | NC | No connect |
| 36 | GND | System Ground |
| 37 | XR(NC) | No connect |
| 38 | YD(NC) | No connect |
❤ Our specific datasheet can be provided! Just contact us by mail.
A1: We are 10 years of experience manufacturing TFT LCD and touch screen.
►0.96" to 32" TFT LCD Module;
►High brightness LCD panel custom;
►Bar type LCD screen up to 48 inch;
►Capacitive touch screen up to 65";
►4 wire 5 wire resistive touch screen;
►One-step solution TFT LCD assemble with touch screen.
A2: Yes we can provide the customize services for all kinds of LCD screen and touch panel.
►For the LCD display,backlight brightness and FPC cable can be customized;
►For the touch screen,we can custom the whole touch panel like the color,shape,cover thickness and so on according to the customer's requirement.
►NRE cost will be refunded after the total quantity reaches 5K pcs.
►Industrial system,medical system,Smart home,intercom system,embedded system,automotive and etc.
►For samples order,it is about 1-2weeks;
►For mass orders,it is about 4-6weeks.
►For first time cooperation,samples will be charged,the amount will be returned at the mass order stage.
►In regular cooperation,samples are free.Sellers keep the right for any change.
As a TFT LCD manufacturer, we import mother glass from brands including BOE, INNOLUX, and HANSTAR, Century etc., then cut into small size in house, to assemble with in house produced LCD backlight by semi-automatic and fully-automatic equipment. Those processes contain COF(chip-on-glass), FOG(Flex on Glass) assembling, Backlight design and production, FPC design and production. So our experienced engineers have ability to custom the characters of the TFT LCD screen according to customer demands, LCD panel shape also can custom if you can pay glass mask fee, we can custom high brightness TFT LCD, Flex cable, Interface, with touch and control board are all available. 
Realted Products
-
21.5 inch CTP Capacitive Touch Screen Panel for...
-
7.0inch 800×1280 TFT LCD Display for face ident...
-
3.5inch 320×240 TFT LCD Display With RTP Screen
-
10.4 inch BOE LCD Automotive LCD LVDS interface...
-
10.25 inch Automative TFT LCD Display with high...
-
7inch 280×1424/7.84 inch 400×1280 Custom TFT LC...
